Barrier Features:
boom barrier gate, gate arm barrier, entrance barrier gate, automatic barrier gate barrier gate system Shenzhen Mama Security Technology Co., Ltd. , https://www.mamasecurity.com
(2) Overhang the surface of the wall decoration line, sill, etc., on the back surface, water; The lower slope of the door and window or the slope is small, the surface smoothness is poor, there is water; the lower floor slope to the inside, no dripping line or eagle Mouth drip line, water along the bottom edge and the vertical wall seam into the insulation layer.
(3) The benzene board under the door and window is higher than the height of the drain hole of the door and window, and the water in the drain hole directly enters the insulation layer.
(4) The roof and external insulation joints are treated unreasonably and leak into the insulation layer.
Precaution
(1) Strengthen design and construction management to prevent cracks in the insulation of external walls (refer to Article 2 above).
(2) The lower surface of the doors and windows, which protrudes from the walls, and the decorative lines, etc., shall have a water drainage gradient of i ≥ 3%. The lower floor and the upper mouth of the doors and windows shall be provided with olecranon drip lines to prevent water from flowing into the insulation.
The water in the insulation layer is due to the useless drip line
The main site of occurrence is: cracks or holes in the outer wall surface; the lower part of the window; the provocation, decorative lines or other components that protrude from the outer wall intersect the wall surface: the wall surface exposes the glass fiber mesh.
1. Big brand with rich experience of export
2. One-stop service to help you solve any access control system issue
3.Our products include standard boom barrier , blue-tooth bulted-in boom barrier ,parking lot toll system
and CCTV detective boom barrier ,advertising barrier
4.Qualify prodsucts and good outlooking packing
5.We can help you gather your cargos at my factory and help you load container for free ,save your money
6.We can send engineer to your countrry to help you install and test .
Cause of water in the insulation layer
(1) Failure to follow the design or construction procedures resulted in the presence of cracks, holes, and other influent sites on the exterior wall.